The Quick Guide to Building a SpeedFusion Connection


#1

This guide is meant for customers who wish to experience SpeedFusion as quickly as possible.

Requirements

To experience SpeedFusion, you need to gain access to two Peplink/Pepwave Routers. If you do not have two Peplink/Pepwave Routers, you can obtain a FusionHub evaluation license. For this example, we will be using a MAX HD2 (device A) on one end and a FusionHub (device B) on the other.

Configuring Device A

1) Copy the serial number from Device B (FusionHub in this case)

2013-12-19_173726

  1. Go to Advanced > SpeedFusion, click New Profile.

Note: if you are using a Balance router, go to Network > VPN > SpeedFusion.

  1. Configure your device
  • Choose a name for your VPN (FH Connection).
  • Enter the serial number from device B as the Remote ID (1179-4F53-F5AB).
  • In the Remote IP Addresses field, enter the IP address of device B (10.10.11.101). You only need the IP address of one end of your SpeedFusion tunnel. Please remember to remove "http://" from the IP address.
  • Click Save.

 

  1. Click the “Apply Changes” button on the top right corner.

Configuring Device B

1) Copy the serial number from Device A (MAX HD2 in this case)

  1. Go to Network > SpeedFusion, click New Profile.

Note: if you are using a MAX router, go to Advanced > SpeedFusion.

  1. Configure your device
  • Choose a name for your VPN (FH Connection).
  • Enter the serial number from device B as the Remote ID (2830-CFD8-B336).
  • Click Save.
  1. Click the “Apply Changes” button on the top right corner.

Congratulations, you have now established a SpeedFusion connection! You can check the status of the connection on the dashboard of each device.

 


SpeedFusion: Unable to establish a VPN connection