So I found this KB: Outbound policies within a PepVPN or SpeedFusion tunnel and have been experimenting along those lines.
As an experiment, I created two tunnels within my SFC config shown in the previous post. The tunnels are: 1 - Bonded (simply all connections bonded) and 2 - WAN Smoothing.
I then setup one Outbound Rule, for any connection on SFC to be directed to tunnel 2. This is using the priority rule. This is on top of the SFC configuration that points my laptop to the tunnel, as explained in the previous post.
However when I enable all this, the laptop connection is going over SFC, but it is going through tunnel 1. There is no traffic routed to tunnel 2.
What am I missing? If I understand that part, I feel I can configure my original scenario.
Regards,
Maciek