Peplink question if possible

[TK_Liew]

Please find the link below to understand the SpeedFusion Bonding and Link Load Balancing.

Combining the bandwidth of all WAN links. 3M + 3M = 6M?

When used with Peplink SpeedFusion VPN Bonding technology, the Peplink Balance can combine the bandwidths of all available WAN links, giving you the maximum utilization of all of your bandwidth. In other cases, traffic will be distributed across all WAN links using load balancing and all bandwidth will be utilized as Peplink Balance distributes the traffic across your Internet links. Peplink SpeedFusion Bonding Using VPN Bonding, Peplink Balance will combine all available WAN bandwidths even w…

You may configure Drop-in if you want to minimize the changes on the existing network.

Deploying Peplink | Pepwave products in Drop-in mode

Drop-in Mode allows Peplink | Pepwave products to be deployed in a network without configuration changes on existing network infrastructure. Example: Pre-Installation In the following network diagram, ISP A provides a 24-bit network 210.10.10.2 / 255.255.255.0, 210.10.10.1 is the default gateway. The Firewall is performing NAT (Network Address Translation) for Local Area Network 192.168.1.0/2 to access the Internet. Firewall settings: NAT Enabled External Interface IP: 210.10.10.2/24 Defau…

If you want the outbound traffic NAT to WAN1’s IP, you may use Priority rule to route the traffic to WAN1 then follow by WAN2.