Its really speedfusion bonding can bonding bandwidth?

[asimula]

me too

[aldwinaldwin]

Can you check the WAN Smoothing and FEC settings? They can cause extra overhead.

Introducing Forward Error Correction (FEC)

Available from firmware version 8.0 for Peplink routers with a SpeedFusion WAN Smoothing license. Introduction When using multicast applications on lossy WAN connections the performance can suffer. To overcome these problems Peplink introduced WAN smoothing, but WAN smoothing has an overhead of at least 50%. This is not always desirable when there isn’t enough bandwidth available. Peplink has therefore introduced Forward Error Correction in Firmware 8.0 FEC is a cousin of WAN smoothing but…

[Rizal_Al_Deny]

Yes i set to high

[SamuelNorris]

If WAN Smoothing is set to high, your device is sending duplicated packets down both of your active WANs.
With FEC The expected overhead of Low is 13.3% and High is 26.7%.

Please set both of these settings to “Off” and try test again.

Hope this helps

[Rizal_Al_Deny]

Thanks sir