Slave and DNS

Everything Else
1

I have two Peplink Balance 200’s. Master and Slave.

I get constant reports from the Slave that the one or both of the WANS disconnects. But it shouldn’t be reporting any errors as it is in standby mode while the Master is working fine.

About DNS issues, on these Peplinks and Peplink 380’s sometimes websites won’t load because of DNS issues. I believe after Peplinks haven’t been restarted after a while they cause the issue. Reversing the DNS entries in the WAN side usually fixes without restarting.

Any thoughts on these two issues?

Thanks,

Todd

2

Hi Todd,

For issues like this please open up a ticket at the following link:

http://www.peplink.com/contact/support/

We would request a diagnostic report from each unit to get the necessary information to provide assistance.

Best regards,

Ron

The Peplink Team