Show inferred public IP in dashboard

Product Discussion Feature Requests
1

When an ISP uses NAT, knowing the public IP of a WAN requires additional steps. For example, one can setup outbound policies per interface and use a service like telnetmyip to determine the public IP of a WAN under layers of NAT.

It’d be nice for debugging (etc) if this were built into the dashboard UI. And it’d be super nice if detecting public IP changes were somehow a part of the health check logic.

Thanks for considering this.

3 Likes
2

good idea… hopefully Peplink can work on integrating that

3

It is shown on the device in Incontrol2

4

The only thing I see is “InControl Detected IP” but that’s just my first/primary WAN which happens to be already be public. I don’t see any way to show the public addresses of my secondary WANs.