Setup and Configuration new Peplink 710

[toannguyen290497]

Hi all, can anyone help me
I had an old Peplink Loadbalance 710 (connect to a switch to connect 4 WAN). Now i buy a new Peplink Loadbalance 710 will connect to that switch and connect more 3 WAN, I want to config HA between my new Peplink Loadbalance to my old Peplink Loadbalance. What’s step i should do now???
Thanks all

[toannguyen290497]

Can anyone help me???

[dennis.hofheinz]

Hi,

please have a look at this post

Configuring 1+1 Backup by High Availability (HA)

1+1 Backup requires a pair of Peplink Balance devices or MAX 700/HD, operating in active-standby mode. When the master device is down, the slave device takes over and handles all the LAN traffic. Peplink Balance 210 or above, MAX 700/HD support High Availability (HA) failover between two Balance/MAX devices based on Virtual Router Redundancy Protocol (VRRP). Periodic VRRP advertisement packets are sent out from the master device to VRRP-specific IP multicast addresses. The slave device assumes …

Best wishes
Dennis

[toannguyen290497]

Thank you, but i want to know propoties step because i had an old Peplink and now i just a new Peplink.

[Rick-DC]

It’s generally recommended that the hardware versions of both routers be the SAME. Is that the case in your situation? If so, then the instructions are here.

Edit: Sorry, @toannguyen290497. Looks like you have two threads going here …