Pepwave MAX BR1 Pro WAN Failover

[AnthonyTeah]

We just purchase Pepwave MAX BR1 Pro to improve WAN Failover.
Wired:8 Static IP
LTE:Dynamic IP
I would like to use the one of the static IP in PEPLINK and one of the static IP in sonicwall firewall TZ600 ,we will doing all the NAT in firewall and initiate the IP SEC to Datacenter TZ600.
Please guide me what i need to configure peplink WAN IP and LAN IP because i realize that if i configure ISP WAN IP and in WAN interface and using public address the LAN IP ,behind the firewall i can not failover to LTE ?

[sitloongs]

Guessing you are looking at the drop in mode deployment for BR1 series.

Please refer to the following post:

$99 Drop-In Mode License Now Available For BR1 Series!

[dropin-rev2] Lately, we’ve been receiving requests for a way to affordably add cellular connectivity to a network without changing the existing topology. In response, we’re now launching a $99 add-on license to enable Drop-In Mode for all indoor BR Routers. This license is now available in the online store, click below to get yours, or discuss in the forum. See Online Store

Configuring Drop-in Mode

Drop-in Mode is Peplink’s transparent/bridging mode that allows you to seamlessly slot your Peplink into an existing network without having to change configuration on your existing appliances. https://youtu.be/ndG1HCSkZLk When operating, the Peplink forwards traffic between the LAN and the Drop-in Mode WAN without performing any IP address translation/bridging the network. The original firewall/NAT’ing device won’t need any additional configuration/any change in the external IP addresses to wo…