Peplink B-380 HAnfiguration

[BensonLEI]

Hi, Guys,

We want to configure two B-380 as the HA pair for three WAN links ( only one LAN cable for each ISP ).

Any example for physical and configuration, thx ?

Need to configure both B-380 or only one B-380 ( so the other one can be auto sync. ) ?

[TK_Liew]

Please refer to the link below.

Configuring 1+1 Backup by High Availability (HA)

1+1 Backup requires a pair of Peplink Balance devices or MAX 700/HD, operating in active-standby mode. When the master device is down, the slave device takes over and handles all the LAN traffic. Peplink Balance 210 or above, MAX 700/HD support High Availability (HA) failover between two Balance/MAX devices based on Virtual Router Redundancy Protocol (VRRP). Periodic VRRP advertisement packets are sent out from the master device to VRRP-specific IP multicast addresses. The slave device assumes …