Manual and automatic configuration of speefusion can cause incompatibilities?


I have seen some strange behaviors recently between a max on-the-go and and fusionhub.
I had a working setup with OTG and fusionhub, speedfusion working fine, configured manually. I redeployed a fusionhub and recreated the configuration via InControl and now my Max OTG is acting strangely.
The PepVPN is marked as starting but all the interfaces are marked as red even if they are green in the dashboard.

The factory reset or fw change didn’t solve it.

Any idea?



Please open ticket here.


Additionally, can you enable SpeedFusion in InControl2?

Thank you.