I have a Cisco RV160 at home that I setup a client to Site VPN. I was able to test the VPN with VPN Access Site manager without any issues. I copied the setup to my pepwave and after it tries to connect it says “Remote side refused this network.” in the pepwave event log. What am I missing? (pepwave is using a cellular network, even if i connect my computer to the pepwave and use the VPN Access manager VPN on the computer through the pepwave it works without an issue)
Cisco Config
Local ID VPN@Cisco
Remote ID VPN@Peplink
Phase I Options
DH Group
Group2 - 1024 bit
Encryption
3DES
Authentication
SHA1
SA Lifetime
3600 sec.
Phase II Options
Protocol Selection
ESP
Encryption
3DES
Authentication
SHA1
SA Lifetime 28800 sec.
DH Group
Group2 - 1024 bit
Pepwave Setup for the VPN
Local Networks
192.168.50.0/24
Remote Networks
Network Subnet Mask
192.168.3.0
255.255.255.0 (/24)
Mode
Aggressive Mode
Preshared Key
••••••••
Local ID VPN@Peplink
Remote ID VPN@Cisco
Phase 1 (IKE) Proposal
3DES & SHA1
Phase 1 DH Group
Group 2
Phase 1 SA Lifetime
3600 seconds
Phase 2 (ESP) Proposal
3DES & SHA1
Phase 2 PFS Group
Group 2
Phase 2 SA Lifetime
28800 seconds