Incontrol2 support for client type on outbound policy

Product Discussion InControl
1

Does InControl2 support the 8.3 feature that allows the selection of client type as a source/destination for outbound policy? I see it in the firmware but not in Incontrol2.

1 Like
2

Anyone? I would like to send all devices of a specific type to a specific tunnel, but I don’t see how to do that on IC2.

Thanks,
-mike

3

Hello, Mike.
I am not a Peplink expert, but looking at my devices not on IC2, I don’t see anything can allow me to do a rule based on the client type, like PC/MAC/IoT/AP. Just IP Address and Mac Address.
Regards,

4

Let me check on this and get back to you for the ETA when this will supported in IC2.

1 Like
5

@mikehar @zegor_mjol ,

Targeted this will be supported in IC2 version 2.13.0 (Outbound Policy - client type - “Source” )

3 Likes