Hi,
trying to sort out - how to make sure my Incontrol2 connection to my devices stays intact during a fiber fail.
Setup is: 1 Balance 20, with 2 pcs SD switches behind.
Theres a VLAN configured on the SD switches as well on the Balance - allowing traffic from any port on the VLAN to reach internet. All works. Traffic to internet works - incontrol works - and intouch also.
Now adding a cellular interface - in order to have Incontrol2 management of the devices during a failure of the cabled WAN.
Trying to use the Advanced - Outbound policy settings to apply a “overflow” rule to the Incontrol2 traffic. But i get no option to choose an interface to overflow to. So i would have expected to see the WAN cellular interface as a selectable option - but it merely gives me WAN:WAN and not WAN:Cellular.
It works if i do “weighted balance” - but this is not what i want. I only want the Cellular interface to be used in case the WAN goes down - and the only for Incontrol2 messages.
Am i doing something wrong or is there a slight glitch in the firmware?