I have setup a speedfusion profile using Incontrol, and it creates a profile I can see in the Speedfusion settings. I need to fine-tune a few features, how do I edit it? Specifically I want to turn on/off WAN smoothing and play with the WAN priorities, just like I can do if I manually create a profile. I can’t figure out how to edit the Incontrol profile anywhere, its not clickable and don’t see any option to edit anywhere, either inside the Peplink directly or inside Incontrol. The attachment shows the VPN automatically created, which is not a clickable/editable link. The test below I can edit. How do I edit the incontrol profile and see the settings I need to edit?
Hi! You can’t edit SpeedFusion settings in the Web Admin if they were created via InControl2.
To edit the SpeedFusion connection, within InControl2 go to:
(Organization or Group level) SpeedFusion VPN > Configuration > Edit
You should then be able to edit these settings in the “Profile Options” section. Enable “Show advanced settings” on the lower left. Don’t forget to save your changes when you’re done.