Hot Failover configuration

Omar_Dehneh · May 12, 2019, 1:24am

How do we configure Speedfusion Hot Failover? I mean Speedfusion maintaining tunnels over all configured WAN connection to ensure instant failover. Configuring different links priorities on the VPN profile only enables failover which needs time tunnel re-establishment over the new link.

sitloongs · May 12, 2019, 11:14pm

May i know your device models ? Beside that would you please share us the WAN status & SpeedFusion status for your setup ?

Omar_Dehneh · May 12, 2019, 11:19pm

Max BR1 to Bakance 1350. WAN and SpeedFusion are up.

sitloongs · May 12, 2019, 11:23pm

What is the firmware version running for both devices ? Can you screenshots and share us the SpeedFusion Status page for both device ? Hot fail-over should showing the backup WAN as standby.

Omar_Dehneh · May 12, 2019, 11:26pm

firmware is 7.1.1. I don’t have access to devices right now but the failover link (3G) is shown as standby. The failover however takes about 10-15 sec.

sitloongs · May 12, 2019, 11:49pm

How you stimulate the fail-over test ?

Are you using the default Link failure detection setting as below ?

If yes, it’s acceptable to for the 10-15 seconds. You can fine tune the settings if you want faster fail-over times.