Firewall rules changes are reverting after a few seconds.

Product Discussion Peplink Balance
1

Whenever I change a firewall rule on my Balance One, either by connecting directly to the management interface or via InControl2, the change “reverts” after a few seconds. The change is visible when I click “save” and “apply”, but after a few seconds the settings revert to the prior state.

I am changing the internal destination ip address for an “allow” rule.

Any suggestions?

2

Sounds like InControl is rolling back the changes - what does the event log say? Have you used InControl in the past to push firewall rules perhaps?

2 Likes