Enforced WAN policy not working

General
1

I live in a country where X has been censored and I have two ISP connections in my PEPLINK 20, WAN 1 is a local ISP (where there is censorship) and WAN 2 is a satellite connections where I have no restrictions. I have set up an outbound enforced policy but it is not working. Any idea what it is?

2

Hi,

What is the setting for your Source & Destination?

Make sure the policy is on the top priority.

image
image1193×477 28 KB

3

I think they are correctly set up.

Web Admin - Balance-8D5A
Web Admin - Balance-8D5A1652×1031 234 KB

4

Part II

Web Admin - Balance-8D5A - Enforced
Web Admin - Balance-8D5A - Enforced1677×1056 203 KB

5

Protocol is set to any, still doesn’t work.

Web Admin - Balance-8D5A - Enforced
Web Admin - Balance-8D5A - Enforced1708×1174 268 KB

6

Just a silly question, but do you have both your WAN connections set as priority 1 connections? If Starlink were priority 2 for example, then it would not be active unless the main priority 1 WAN is deactivated. In that case the traffic to X would not be routed out and it would look like it is still censored.

7

image
image1644×176 24.2 KB

8

Just make sure both the Internet source are on Priority 1 ( Dash board)

image
image994×608 37.1 KB

You may try to set any protocol instead of TCP

9

Change it to a priority rule with just the WAN you want to use in it. See if that works.