Drop-in mode configuration of a B-380

[BensonLEI]

Hi, Guys,

I am new to Peplink.

As I understand that drop-in mode, an WAN IP is assigned to the Peplink B-380.

May I know if I can configure the B-380 with a Public IP of the different ISP ( e.g. three ISP links, one ip from different ISP, so total 3 Public IPs are configured in the Peplink ) to prevent ISP link down ?

Or how I connect to the Peplink from public if the ISP is down ?

Thx

[TK_Liew]

Please refer to the link below.

Deploying the Peplink Balance in Drop-in mode

Drop-in Mode allows Peplink Balance to be deployed in a network without incurring any configuration changes to existing network devices. Example: Pre-Installation In the following network diagram, ISP A provides a 24-bit network 210.10.10.2 / 255.255.255.0, 210.10.10.1 is the default gateway. The Firewall is performing NAT (Network Address Translation) for Local Area Network 192.168.1.0 to access the Internet. Firewall settings: NAT Enabled External Interface IP: 210.10.10.2/24 Default Gat…