Disable Automatic Dynamic routing

[KPS]

Hi!

I think, you are using OSPF to do dynamic routing between your devices - connected through PepVPN/Speedfusion, but is it possible to configure only static routes?

The thing, I want to avoid:
What happens if somebody adds a second network in a branch office that conflicts with another net? I think, he can break the connection to another branch-office.

Thank you for your help!

KPS

[TK_Liew]

You can add the desired subnet at Network Advertising (Network > OSPF & RIPv2). So, a new subnet will not be advertised if added by someone accidentally.

[KPS]

Hi!

Sorry, but I do not fully understand that.

Peplink0 is my “hub”.

Peplink1 is connected to network 10.10.10.0/24.
Peplink2 is “misconfigured” to the same network and advertises this one, too.

How can I tell Pepwave 0 to never route 10.10.10.0/24 to anything else than Peplink1?

[sitloongs]

@KPS

Similar request as the forum post below:

Speedfusion crashes when there are route conflicts

Had a problem tonight that took us a while to diagnose. This will be complex to explain, but I believe that the speedfusion engine in one of my Balance 710s was crashing every ten or twelve minutes, and that it was caused by some route conflicts. Setup: Two data centers. Each has two pairs of B710 in high availability. One pair currently with 290+ speedfusion peers, the other with about 40 (I am looking at starting to use fusionhub for growth) The B710s in the two data centers have speedfu…

Can you please add you comment for the forum post above ?

[jmpfas]

I have asked for the OSPF software to see and alert on duplicate routes, possibly in real time.
Humans make mistakes. As someone with 300+ dual-hub VPN clients, I can tell you that duplicate routes WILL happen. So my request is that the hub warn the user “Yo! Idiot! You are trying to add a duplicate route. This subnet also exists on device XXXX”