Configure PepWave Surf On-The-Go in Bridge Mode using Ceullar USB Modem

Product Discussion Pepwave AP & Surf
1

Hello,

I have a PepWave Surf On-The-Go with a Verizion MiFi USB Modem. I’d like to have it setup as a failover for my current network if the cable goes out. Router is a Ubiquiti EdgeMax handeling DHCP / Firewall / Load-Balance / Failover

When I set the device to bridge mode, the cellular option disappears. Is this possible to configure the device this way? All i want it to do is pass the internet from the USB modem into my router, bypassing any routing / dhcp capabilities of the pepwave.

Thanks!

2

This is not supported. The bridge mode is for the Wi-Fi as WAN and when you are using a cellular USB modem a NAT will always be applied.

Thanks.

1 Like