Bypass-peplink balance

[TK_Liew]

Please refer to the FAQ below.

How to set up Peplink QoS, and what is its capability?

QoS is used to allocate bandwidth and prioritize applications to individuals and to groups of users. User Groups On select models, you can define user groups by IP and subnet. Bandwidth controls and application priority can then be applied according to user groups. [image] By Bandwidth Bandwidth reservation per user group under full load Defines how much minimum bandwidth will be reserved to each user group when a WAN connection is in full load. [image] Per user group bandwidth control …

1. I would suggest performing NAT on your firewall (which behind Peplink router) as below. So Peplink router will see 2 IPs only from your firewall.

• IPs of CEO and CTO NAT to an IP.
• The rest of the IPs NAT to another IP.

2. Assign the CEO and CTO NATTED IP into Staff group and assign the common users NATTED IP into Guest group. Then enable Individual Bandwidth Limit with 50% bandwidth for Staff and 50% bandwidth for the Guest.

3. Enable Group Bandwidth Reservation with 50% for Staff and 45% for Guest in case the WAN link is full load.

4. Configure upload and download bandwidth on Peplink’s WAN interface.

Hope this helps.