Balance 380 and Barracuda X300


#1

I current have a Balance 380 for my office and I just ordered a Barracuda X300. I am currently and want to continue to use the 380 for my router and VPNs but I want to add the X300 for the firewall. I have only one WAN connection at this point so would I just install the X300 between my cable modem and the 380? Thanks for the help


#2

Hi,

There are two deployment mode that you can consider here.

  1. B380 NAT mode (Please refer to the attached diagram)


  2. Drop-in mode
    http://www.peplink.com/knowledgebase/deploying-the-peplink-balance-in-drop-in-mode/

Please note that the IP showing in the diagram is just a example IP given for you to further understand the design. You have to change the IP settings base on your defined network.