Balance 20x Virtual WAN Port

Product Discussion Peplink Balance
1

I have a Balance 20x with Firmware 8.3.0 and Promecare contract.
I configure Virtual WAN on LAN port. It connects but not working. Do i need to downgrade firmware?

2

Hi,
What is you Network Topology ?
Do you have configured some LAN port with a VLAN corresponding to the VLAN WAN ?
If yes, what is the type protocol needed for your WAN connection ( DHCP, PPPoE, GRE etc… ) ?

3

Hi

image.png
image.png1296×396 45.9 KB

Both Wan1 and Wan2 have static ips (direct connection). I have conection between wan1-wan1 and wan2-wan2. but if i disconect wan1 the conection between sites falsdown.

Yes, Both Wan1 and Wan2 have the Vlan there vlan associated, and Wan2(LAN3) have VLAN.

4

What lan port do you have associated with on the vwan? or do you have a small network switch breaking out the vlans? Can you share pictures of your pepwave vwan config and port config?

5

Have you created a speed fusion tunnel between both 20X ?

6

Hi Korantin,

No, I didnt create a speedfusion tunel between both balances. Is that necessary?
I have a sfc relay and client conection but with mobile ports as backup.

7

If you want reliable site to site vpn between both of your 20X you need to create a speed fusion tunnel that include both WAN, you can do it manually if you don’t use Incontrol2 or by Incontrol2 in the section Speedfusion VPN

8

Hi,
Create speedfusion vpn with both WAN1 and WAN2 and works perfect.

Thanks.

1 Like