Balance 20 routing vLAN's through dual WAN connections


#1

I normally work with Adtran routers, but like what I’ve seen from the Peplink routers. I have a client with two locations, using WAN failover at each location. I want to create two vLAN’s at each location. (One for their computers and one for their IP phone system) Can I program a specific vLAN to go out a specific WAN port? If a WAN connection is in failover mode then I obviously want everything to go out the lone working WAN connection. Is this possible? Thanks for any help.


#2

Yes, firmware 6.1 now supports 802.1q VLANs and you can create custom outbound rules based on the new source IP addresses.