Good day. I see the datasheet for the AP-ONE-AC-Mini states bridge mode is supported, yet, I cannot seem to find any documentation supporting how to use it as a layer two bridge to a wired device.
Use case is to provide LAN access to a wired client using Wi-Fi as it’s uplink.
Bridge mode is referred to in the manual as bridging or joining wireless clients to an ethernet cable.
I believe what you are wanting is using the AP as a wireless client to an existing wireless network and connecting a wired device that way.It’s not supported in that manner.
If you have a peplink router that supports mesh you can setup both of the pepwave router and the ap as mesh devices. It would then allow uplinking a wired device over wifi.
To do a wifi client in the way you are thinking you would need to use their Device connector series(no longer supported) or a soho/20x/b one and enable the wifi-as-wan wan to uplink wired clients.
You can find this information here:
Depending on which hardware revision you are using it is linked below.
AP One AC Mini HW2 3.9.3 Online Manual
AP One AC Mini HW1 3.6.3 PDF Manual
This topic was automatically closed 540 days after the last reply. New replies are no longer allowed.