Adding a PepWave one AP to an existing Balance Two router

Everything Else
1

I am having trouble configuring the Pepwave One AP.
It is connected to a LAN port on the Peplink Two but does not show up on the AP management features tabs.
The firmware is the latest.

2

No clue with just this info, but there’s always the old, “are you absolutely certain the ethernet cable is OK?” If you have a tester, that might be a good first step.

3
  1. Make sure you’ve enabled the controller …
    2021-06-13_13-18-20
    2021-06-13_13-18-201136Ă—263 77.3 KB
  2. Can you see the AP in your list of connected devices LAN-side? [essentially what @Madcodger is suggesting.]
  3. Do a factory reset on the AP.
1 Like
4

Factory reset was the fix. Thank you.

5

You are most welcome. :<)