Hi,
Do note that the recommended Balance model to handle 10 Active WANs will be Balance 1350 (Up to 13 WANs).
Seem you have owned the Balance 710 & Balance 380 , do consider the below setup for the Balance 710 & Balance 380:
Balance 710:
Outbound Policy - Weighted Balance (Make sure “Load Distribution Weight” is defined by on WAN load)
Balance 380:
outbound policy - Weighted Balance (Make sure “Load Distribution Weight” is defined by on WAN load)
P/S:
- Do note that the above design is only for outbound traffics WAN Load-balancing.
- Dynamic outbound load-balancing algorithm may not work well for such design
For USB as WAN, please refer to the forum link below:
http://www.peplink.com/knowledgebase/experimental-support-for-usb-ethernet-adapters/
Thank You