I configured the HA between two peplink 710 units for a client and I synchronized the configuration between the master and the slave automatically. When i do some configuration in the master i have to synchronize it manually between the units.
The client would like that the configuration must be automatically every time without any administrative charge when he do some changes in the master unit.
I took a screenshot of the HA knowledge base guide. Basically once Config Sync is enabled. All changes made on the Master Peplink will automatically be applied to the slave unit.
I did it when i configured my HA and the configuration is synchronized from the master to the slave. But the client would like to have this synchronization automatically every time when he change or add a new configuration in the master unit. It’s is possible?
I apologize for the confusion. I am not 100% sure of the time that it takes for the Slave to receive the update from the Master. I don’t believe that it is automatic. I will escalate this to get a answer for you to determine how long it takes the Slave to apply the update when changes are made on the Master.
Regarding the configuration sync. Slave unit should receive the configuration changes from Master unit in 5 minutes. For example, if something is changed in Master unit, Slave unit will get the updated configuration in 5 minutes.
Hi all
I have pair Peplink 710 and now i config HA for them. If i enable Configuration Sync. so let me know what’s the configuration on Master can sync to Slave (LAN configuration, WAN configuration,…) or all the config on Master will sync to Slave.
Thankss
If you think about the security side of your question, syncing on the WAN side means you need to open the firewall(s) on the WAN side between the devices, so logically the syncing will be done on the LAN side.