VRRP and LAN side Switch

Product Discussion Peplink Balance
4

Hi,

Base on the description given, you are referring to the Peplink HA for “Fully Mesh Network” & “non Fully Mesh Mesh network” and both are supported by B305 (Make sure B305 is on HW2).

  1. HA for "Fully Mesh Network:

Peplink 1 Lan 1 -> Switch 1 Port 1
Peplink 1 Lan 2 -> Switch 2 Port 1

Peplink 2 Lan 1 -> Switch 1 Port 2
Peplink 2 Lan 2 -> Switch 2 Port 2

Switch 1 Port 3 -> Server 1 Nic 1
Switch 2 Port 4 -> Server 1 Nic 2

For more information, please refer to the attached diagram:

For Full Mesh Network, LACP feature is required (This will be scheduled new features for Firmware version 6.2.1), else you may consider to use LAN switch Spamming Tree Protocols to block one of the redundant LAN port to avoid looping.

  1. HA for “non Fully Mesh network”

Peplink 1 Lan 1 -> Switch 1 Port 1
Peplink 2 Lan 1 -> Switch 2 Port 1

Switch 1 Port 3 -> Server 1 NiC 1
Switch 2 Port 4 -> Server 1 NIC 2

For more information, please refer to the attached diagram:

We have no idea whether the Netgear Switch for the given link are capable to support the above design, possible please verify with Netgear support & they should be the expert that can provide you such info.

Thank You

1 Like