Trying to setup Layer 2 VPN

I’m trying to setup Layer 2 VPN with multiple HD2-minis all connecting to the same FusionHUB following instructions from this site. When done and applied, the Dashboard PepVPN status just loops from “Starting…” to “Creating Tunnels…” and back to “Starting…” Any ideas?

Layer 2 PepVPN is not supported in FusionHub. You may need to try with Balance router. Please refer to the link below to setup layer 2 PepVPN.

http://www.peplink.com/knowledgebase/setting-up-a-layer-2-pepvpn-profile-in-firmware-6-2/

1 Like