SpeedFusion failed links don't come back online

Product Discussion Peplink Balance
1

This is mostly anecdotal because when a SpeedFusion link fails, it doesn’'t make an Event Log entry but…

I have noticed a few times recently that when a WAN link fails, it will not come back online by itself.

First time both WAN1 and WAN2 were down and I was on Mobile Web exclusively. Rebooted B210 to solve.
Second time WAN2 was down but was passing non-SpeedFusion traffic fine. Disconnected/Connected WAN2 to solve.

I am running 6.2.2 build 3008 on a B210 HW v3.
Is this a known issue on this version? I haven’t seen this behavior on previous FW releases.

2

Hi,

May I know remote SpeedFusion peer also running v6.2.2? This may happen if remote peer is running older firmware version.

3

Both units are identical. B210 HW v3 running 6.2.2 build 3008.

4

Appreciate if you could create a support ticket so that we can take a closer look.

5

It hasn’t happened since but I’ve opened a ticket anyway.