Routing a PC to a single WAN

Hi… i have recently switched over to a peplink Balance 30.

I run multiple PC’s through 2 DSL lines.

Can you please explain how to direct all incoming and outgoing traffic on a single pc through one of the Wan channels…

e.g. I want all traffic on 192.168.1.12 to travel through Wan 1 only. Then i want all traffic on 192.168.1.10 to go through Wan 2 only.

Please make it as simple as possible as I’m far from a beginner but I’m no expert :slight_smile:

Thanks.

Gary.

You can do so using Custom Outbound Policy. Go to Network -> Outbound Policy -> Change to Managed by Custom Rules.

You can then define a Priority / Enforce rule for your PC base on their Source IP (192.168.1.12), then arrange the WAN order.

You can learn more about the difference between Priority / Enforce here: http://www.peplink.com/technology/load-balancing-algorithms/