Provide remote web access to firewall behind PepLink LTE

Product Discussion Pepwave MAX
1

Hi there,

I am unable to access my firewall remotely which sits behind a PepLink BR1 configured for failover. I have a PepWAVE BR1 running ethernet WAN and LTE. I setup a port forward on the PepWave BR1 from LTE/WAN to the firewalls WAN IP but i am still unable to browse to my firewalls web admin page behind the PepWAVE. Is there anything else i need to configure?

PepLink BR1 interfaces
LTE 10.xxx.xxx.xxx
LAN/ WAN 69.xxx.xxx.xxx
LAN 192.168.0.1

Firewall interfaces behind PepLink BR1
WAN 192.168.0.2 ( connected to peplink LAN port)

2

Hi Jarrad, welcome to the forum community , have you set a port forwarding inbound from the WAN of BR1 to ip address of Firewall ?

3

Yes. From the BR1 WAN to the firewall WAN. Access is via HTTPS 443.

4

have you tried to capture traffic on the wan of firewall ?
Do you have only a pubblic ip or have multi pubblic ip on the wan of BR1 ?
If do you have only IP, can you try to make a port mapping on BR1 , I think the problem may have been due to the fact that port 443 is also used natively by peplink .