Peplink SpeedFusion VPN to multiple devices

General
1

Hi all,

I’m currently working with several Peplink Balance 20X units and I’d like to check if the following setup is possible:

I want to have one Peplink Balance 20X establish SpeedFusion VPN connections to multiple other Balance 20X devices at the same time.

  1. Is this supported (i.e., one Balance 20X acting as a hub connected to several peers)?
  2. If yes, is there any way to bind each VPN connection to a specific LAN segment?

Here’s the reason for this question:
Some of the remote sites have identical LAN subnets (e.g., 192.168.1.0/24), which causes routing conflicts when all VPNs are up.

I’d prefer not to change the existing LANs, since I only need VPN access to a specific subnet that doesn’t overlap with the others.

So my question is:

  • Can I create a dedicated LAN/VLAN just for VPN use, so that this dedicated subnet can be used for routing without conflict?
  • Or is there another recommended way to avoid LAN conflicts in multi-site SpeedFusion setups using Balance 20X devices?

Any configuration example or best practice would be greatly appreciated!

Thanks in advance.