Peplink Balance 30 and access point TP-Link, D-Link…etc

Good evening everyone,

I have had a Peplink Balance 30 for 5 years, it had Firemware version 6, it worked fine as a router combining 3 ADSL connections and it shares the connection to 3 access points.

When I upgrade the Peplink Balance 30 to Firemware version 8 it does not communicate with the access points.

Do you have an explanation for this problem?

Thank you

Welcome to the forum!
A lot has changed in VLAN and routing since firmware 6.

I would suggest a factory reset in case the old config is incompatible and see if the APs start working then.