Peplink 1350 High Availability

[dennis.hofheinz]

Hi MathTec,

welcome to the Peplink Forum.

Please have a look at this post

Configuring 1+1 Backup by High Availability (HA)

1+1 Backup requires a pair of Peplink Balance devices or MAX 700/HD, operating in active-standby mode. When the master device is down, the slave device takes over and handles all the LAN traffic. Peplink Balance 210 or above, MAX 700/HD support High Availability (HA) failover between two Balance/MAX devices based on Virtual Router Redundancy Protocol (VRRP). Periodic VRRP advertisement packets are sent out from the master device to VRRP-specific IP multicast addresses. The slave device assumes …

This should be really helpful

Regards
Dennis