Outbound policy can not control Multi-SpeedFusion traffic

[BensonLEI]

Hi, guy

I have to create multi-SF tunnels under the same remote ID( or the only Parent SF ) — this is the only way to create multi-SF tunnels:

1. This parent SF must include all WAN links for all SF tunnels ?
2. Unfortunately, the 1st child tunnel (default tunnel ) is responsible for detecting and learning LAN subnets/information from the remote site ?

Which way to control the default tunnel traffic ? since outbound policy can not do this ( outbound policy can only control other child tunnels’ traffic )?

[MartinLangmaid]

Discussed on your other post here

Two SpeedFusions in one site

Hi, Martin, For my case ( no Site C ): SiteA (learned by SpeedFusion):: 192.168.1.0 /24 192.168.10.0 /24 SiteB ( learned by SpeedFusion): 172.168.2.0 /24 172.168.20.0 /24 It works only for the following configuration: Source: Any Destination: PepVPN Profile, Tunnel2 Protocol: …… Algorithm: Enforced Enforced Connection: VPN: Tunnel 2 My configuration is as below: Source: Any Destination: IP network, 172.168.20.0 /24 Protocol: Any Algorithm: Enforced, Enforced Connection: …

[BensonLEI]

Hi, Martin,

Great thx