Outbound FusionHub on AWS

Product Discussion FusionHub
2

Hi,

You need to

  1. Do not enable “NAT” mode in SpeedFusion profile configuration
  2. Enable “SpeedFusion Peers Access Internal Network” in FusionHub WAN page
  3. Enable “IP Forwarding” and “Apply NAT on Remote Peer’s outgoing Internet traffic” in FusionHub WAN page (click the “?” next to “Routing Mode”, there is a link to enable this option)
  4. Disable “Source/Dest. Check” of your server instance and FusionHub instance, refer to page 65,66 of installation guide. You may need to wait 10 minutes for this change to take effect.
  5. Add static route in AWS gateway to route Balance 30 LAN subnet via FusionHub (or add static route to the server)
2 Likes