I’m looking for some guidance and direction on a layer2 VPN I’m attempting to configure with speedfusion, but I’m having an issue with the tunnel coming up. I deploy standard speefusion VPN’s on regular basis and have never really ran into any issues, but this is my first attempt at the l2 VPN.
Scenario:
Site A: Fusion hub
LAN : 10.238.10.0/24 (only network at this side)
Site B: Balance 2
LAN: 192.168.1.0/24
VLAN 10: 10.238.10.0/24
I’m wanting the L2 bridge to be utilized for the VLAN 10 network to transpire to the site A due to some software/equipment needs.
What I have done is create the tunnel from inControl which I typically do. I think connected to the site B balance 2 and added the VLAN2 interface as a bridged interface on the existing profile I created from incontrol.
VPN status goes from starting, building tunnels and then starts over.