IPSEC VPN config bug?

Hi.
I Have been setting up a config for an IPSEC VPN between a Max BR1 and a Balance 380. the issue observed occurs on both devices.
When creating a remote network ID to anywhere (i.e an internet hop) with an address of 0.0.0.0/0 the devices for some reason applies a /32 mask when you apply the config e.g 0.0.0.0/0 becomes 0.0.0.0/32


upon initial configuration the VPN will establish ok but if dropped it will not reconnect and indicates a network ID mismatch.
This appears to be a bug but I am new to the product so it maybe just a misinterpretation of the IPSEC delivery on Peps ?
Any help appreciated

Hi mr chips,

This is not the expected behaviour.
Can you share which model Peplink you are using and what version of firmware are you running?

Thanks!

1 Like

Hi Erik
The remote device is Pepwave MAX BR1 LTE - Firmware 7.0.1 build 2621
The hub / terminating device is a Balance 380 with firmware version: 6.3.4
regards