What we are trying to do is set up the Peplink in our production network with our two ISP. Below is a diagram of how our network is set up and where we would like to put the peplink.
Paetech Router 220.127.116.11WAN2… Comcast Router Bridge mode WAN 1
Cisco Router 18.104.22.168
I have tried setting the peplink into drop in mode with and address of 22.214.171.124 and having the gate way 126.96.36.199 but this did not work i have also tried manually putting those setting in and that did not work. Now when i connect the peplink to my computer with the two WANs i can set the Comcast to dhcp and it sets up the IP address to 10.1.10.10 and i have connectivity. The main reason we are setting it up this way is that our Cisco router has a VPN connection so if the Comcast goes down we would still like it to be able to switch over to Paetech and have connection. Also is there a way to be able to log into the peplink when i set it in place, before i was configuring settings and then seeing if it works if it doesn’t reset it to default, connect it to my computer and the try again. Any help would be greatly appreciated.