Knowledgebase   Tips and Tricks


PepVPN / Speedfusion tunnel selection based on geographic location (1)
Configure Captive Portal in InControl2 (17)
How to Configure Inbound Port Forwarding (9)
Configuring IPsec to Cisco IOS using X.509 Authentication (1)
How to Better Manage Firmware Updates (2)
[Tutorial] OOBM via MAX Transit Serial Interface (3)
Understanding Inbound Load Balancing (11)
Outbound policies within a PepVPN or SpeedFusion tunnel (1)
What is an IC2 subscription and it's relationship with Warranty Coverage? (1)
Exclude WAN connections from an Outbound Policy "Priority" WAN list (1)
Obtaining a Diagnostic Report from a Peplink Balance or Pepwave MAX Device (4)
Health Check Mechanisms Against Link Failure (13)
Configuring an External Splash Page for Captive Portal (5)
Configuring SpeedFusion behind a firewall (4)
Accessing GPS Info from Pepwave MAX Routers ( 2 ) (34)
How does device communicate with Peplink InControl 2? (1)
Determining the Serial Number, Firmware Version, Hardware Revision, and Modem Support Version of a Peplink Device (5)
How to Enable Remote Packet Capture with Wireshark (16)
Geo-fencing for GPS enabled devices (17)
How to Configure Layer 2 SpeedFusion VPN (8)
Configure IPsec to Juniper SSG Firewall using X.509 Authentication (4)
Firmware Upgrade Procedure for High Availability Router Pair (6)
Firewall rule management in InControl2 (4)
Properly Configuring Your Firewall Rules (3)
Forwarding GPS information to External IP Address (5)
How to Use USSD Codes on Cellular-Enabled Routers (4)
High Availability (HA) Failover Using the BR1 (5)
FusionHub Sub-Tunnel Routing (1)
Pepwave Max Active / Active (1)
Peplink DDNS service : Find my Peplink (1)